回转风机的齿轮箱不能进水，尤是正常运转时，不能进入，一旦进水，很可能会造成润滑油的失效，造成齿轮的损坏，那么设备齿轮箱进水怎么办？下面甘肃回转风机厂家给大家说明一下。

The gear box of the rotary fan can't be filled with water, especially during normal operation. Once it is filled with water, it is likely to cause the failure of the lubricating oil and damage the gear. So what should we do if the gear box of the equipment is filled with water? Next, Gansu rotary fan manufacturers give you an explanation.

1、冷却水管破裂导致油箱进水，这种情况下，要及时停车，不能进行工作，如果是冷却水管出现了破损，那么这种情况是很严重，停车之后，需要对油箱进行拆卸，还需要对风机的齿轮进行检查，看是否存在损坏的情况。

1. If the cooling water pipe is damaged, the situation is very serious. After the shutdown, the oil tank needs to be disassembled, and the gear of the fan needs to be checked to see if there is any damage.

此种情况，只能拆卸维修，将水冷管修缮之后，经过测试，在重装上去，检查回转风机能否正常工作。

In this case, it can only be disassembled for maintenance. After the water cooling pipe is repaired, it is tested and then re installed to check whether the rotary fan can work normally.

2、闲置风机油箱进水，如果是闲置的风机，因为人为的原因，造成的齿轮箱进水，可以打开油箱底部的泄油孔，将里面的润滑油和水分排放干净，然后放置几天，让里面的水分蒸发一下，然后再用润滑油洗一遍，油箱注入润滑油之后，盘动一下皮带轮，试运行看下效果，如果存在问题，要及时停车。

2. Idle fan oil tank water, if it is idle fan, because of human reasons, caused by the gearbox water, you can open the oil drain hole at the bottom of the oil tank, the inside of the lubricating oil and water discharge clean, and then placed for a few days, let the inside of the water evaporate, and then use lubricating oil to wash again, after the oil tank is filled with lubricating oil, turn the pulley, test run to see If there is a problem, stop the car in time.

感谢您的阅读，希望以上内容对您有所帮助，如您想了解更多精彩内容请点击我们的官网：甘肃回转风机厂家。

Thank you for reading, I hope the above content is helpful to you, if you want to know more wonderful content, please click our official website: Gansu rotary fan manufacturer.

相关文章： 陕西离心式风机厂家 净化器 气力输送设备厂家 油烟 甘肃回转风机厂家